So as I said on Sunday I put my baby into a ditch. It was a hard hit and had to be winched out of the hole. I didn’t really think about taking pictures mainly because I’m not a big fan of documenting my stupidity. At this point though I kind of wish I had. It would make a great commercial.
The drive home on Sunday had a shimmy though the steering and the wheel was no longer aligned. I spent last night with the pressure washer removing the concrete clay caking the tires and undercarriage. I removed a large quantity of clay that was caked on to everything including all throughout the wheel. By the end I was covered in mud from it flying off while cleaning. I only blasted the mud off though, she will get a bath this weekend. Tomorrow, if I get the green light, I shall go do something special for a post.
This morning I dropped her off for an alignment check and to have the front end looked at in detail on a lift. Also if they could I wanted my steering wheel put back to center. While driving in this morning there was no vibration through the steering, good it means that the wheel was out of balance from the clay, which I expected. The truck tracked well and didn’t drift so the alignment seemed like it would still be good but I wanted numbers.
Well I got the numbers back and everything, remained within spec. I didn’t bump it out of alignment, didn’t bend a tie rod, didn’t do a damn thing to that truck other than de-center the steering wheel. That’s right, all that happened from a trip into the ditch was that my steering wheel was no longer pointed the correct direction for center. They say “Built Ford Tough” for a reason. I just don’t like finding out or pushing those limits first hand.
This weekend she’ll get a nice bath and right now I’m debating on a road trip with her in September. I just need to talk with some friends to see if we can split a hotel room.
Barron is the owner, editor, and principal author at The Minuteman, a competitive shooter, and staff member for Boomershoot. Even in his free time he’s merging his love and knowledge of computers and technology with his love of firearms.
He has a BS in electrical engineering from Washington State University. Immediately after college he went into work on embedded software and hardware for use in critical infrastructure. This included cryptographic communications equipment as well as command and control devices that were using that communications equipment. Since then he’s worked on just about everything ranging from toys, phones, other critical infrastructure, and even desktop applications. Doing everything from hardware system design, to software architecture, to actually writing software that makes your athletic band do its thing.