Today’s Lesson In Manufacturing

Via a friend I discovered these two videos on 22 rim-fire manufacturing.  It’s doubly neat to me since this is factory is quite literally down the hill from me.  Some of the regulars at the matches work for ATK as well.

Neat and educational.

Barron is the owner, editor, and principal author at The Minuteman, a competitive shooter, and staff member for Boomershoot. Even in his free time he’s merging his love and knowledge of computers and technology with his love of firearms.

He has a BS in electrical engineering from Washington State University. Immediately after college he went into work on embedded software and hardware for use in critical infrastructure. This included cryptographic communications equipment as well as command and control devices that were using that communications equipment. Since then he’s worked on just about everything ranging from toys, phones, other critical infrastructure, and even desktop applications. Doing everything from hardware system design, to software architecture, to actually writing software that makes your athletic band do its thing.

About Barron

Barron is the owner, editor, and principal author at The Minuteman, a competitive shooter, and staff member for Boomershoot. Even in his free time he’s merging his love and knowledge of computers and technology with his love of firearms. He has a BS in electrical engineering from Washington State University. Immediately after college he went into work on embedded software and hardware for use in critical infrastructure. This included cryptographic communications equipment as well as command and control devices that were using that communications equipment. Since then he’s worked on just about everything ranging from toys, phones, other critical infrastructure, and even desktop applications. Doing everything from hardware system design, to software architecture, to actually writing software that makes your athletic band do its thing.
Tagged . Bookmark the permalink.

3 Responses to Today’s Lesson In Manufacturing

  1. Lyle says:

    Nice. I’ve wondered for some time how the priming was done. I’d heard the cases were spun to distribute the compound into the rim, but could only speculate as to how the metering was done. Turns out it’s very simple, which is usually how things are done best. Now where do we buy those multi-chambered loading dies, and the presses that use them? I’d like to be able to size, trim, prime, charge and seat, each process doing 50 or 100 rounds in one stroke. I guess it’s all just a matter of money. Keeping all that equipment calibrated must be a lot of work too.

  2. Tango says:

    Before you try, I already asked them. No, they won’t sell to individuals.